What is pointing masonry

It is formed by steel or ironed with a concave edge. It looks good but will damage easily when compared to other types. In this case, the mortar is pressed first at the anchored joint and finished with the face. While the pressed mortar is green, the channel or narrow channel is cut in the center of the channel, which is 5 mm wide and 3 mm deep.

This groove is then filled with white cement mass, projected beyond the face of the joint by 3 mm. If the projection is made in the mortar , it is called a pointing bastard or half a bend point. This is formed by forming a V-groove in the levelled finishing face.

Weathered Pointing. This is done by making a V-shaped projection. Pointing, in building maintenance, the technique of repairing mortar joints between bricks or other masonry elements. When aging mortar joints crack and disintegrate, the defective mortar is removed by hand or power tool and replaced with fresh mortar, preferably of the same composition as the original.

Pointing , in building maintenance, the technique of repairing mortar joints between bricks or other masonry elements. Flush pointing is when mortar is pressed hard in the raked joints, and finished off flush with the edge of masonry units. The edges are then neatly trimmed with a trowel and straight edge. Concave pointing is formed by making the mortar flush with the face brick then struck with a brick jointer.

Hey, I am Krunal Rajput. The Man Behind CivilJungle. I started this site to spread knowledge about Civil Engineering. I am a Degree Holder in Civil Engineering. Your email address will not be published. Important Point. Pointing in Construction Pointing, in building maintenance, the technique of repairing mortar joints between bricks or other masonry elements.

When aging mortar joints crack and disintegrate, the defective mortar is removed by hand or power tool and replaced with fresh mortar, preferably of the same composition as the original What is Pointing?

Beaded Pointing. The upper edge of the joint is about 3 to 6 mm pushed back inside from the face of the brick. This joint helps to dispose of water quickly. When the lower edge of the joint is kept inside from the face of brick or stone, it is called overhand struck pointing. But it will not make an adequate joint because water may collect in the joint. Beaded pointing is made with the help of a steel or iron rod having a concave edge.

Beaded pointing provides a better appearance, but it is susceptible to damage and maintenance is difficult. Difference Between Plastering and Pointing. Save my name, email, and website in this browser for the next time I comment. Table of Contents. It gives good appearance. While the pressed mortar is green, groove or narrow channel is cut in the center of groove which is having 5mm width and 3mm depth. This groove is then filled with white cement putty, kept projecting beyond the face of the joint by 3 mm.

Join Join TheConstructor to ask questions, answer questions, write articles, and connect with other people. Have an account? Log in Now. Join for free or log in to continue reading Remember Me! Don't have account, Join Here. Forgot Password Lost your password? Ask A Question. Flush Pointing 2. Recessed Pointing 3. Beaded Pointing 4. Struck Pointing 5. Rubbed, Keyed or Grooved Pointing 6. Tuck Pointing 7. V- Pointing 8.